Energy-saving coating PROTERM 600

Energy-saving coating PROTERM 600

Thermal insulation of objects with operating temperature of + 400 ° C and short-term peak loads up to + 600 ° C * .

Attention! The material is applied only on the surface from -30 ° C to + 35 ° C.

This modification of PROTERM ®can serve as an ideal solution for the need for thermal insulation of hot water pipelines, boilers, steam lines, cooling systems, tanks, tanks, metal structures, as well as energy objects with operating temperatures up to + 400 ° C.

A dry layer of heat insulator forms a strong polymer coating on the surfaces.

Application of the thermal insulation coating PROTERM ® 600 provides the following objectives:

the possibility of using the coating on virtually any surface;

prevention of thermal burns of personnel;

reduction of labor, time and financial investments for repair and construction works;

preservation of the initial load on building structures;

optimization of temperature conditions;

The ability to apply coating on surfaces with a complex configuration.

Energy-saving coating I PROTERM ® may be applied to air and airless spray.

Methods of application:

Pneumatic – pressure 1,5 – 2,5 atm;

Airless – pressure 80-120 bar, nozzle diameter (inch) – 0.013 0.015, 0.017;

Spray angle depending on the shape of the surface to be painted 20, 30, 40;

When applied to the surface, a smooth wet film should be formed without omissions, streaks, shakiness and other defects.

Main parameters of use:

Applied at ambient temperature: -30 ° C to + 35 ° C, relative air humidity not more than 80%;

It is forbidden to paint on a damp surface and at a wind speed of more than 10 m / s;

It is applied on surfaces with temperature: -30 ° C to + 35 ° C, the temperature of the surface to be painted should be 5 ° C above the dew point;

Recommended thickness of one wet layer: 0.5 mm – 1.0 mm ;

Interval overlap at t в = + 20 ° С: 2 – 4 hours ;

Theoretical consumption of the material: 1,2-1,5 l / m 2 ; 0,5-0,7 kg / m 2 – with a layer thickness of 1 mm ;

The main color of the coating is gray ;

The solvent is orthoxylene ;

After drying, the coating layer operates in the temperature range: -60 ° C to + 400 ° C, short-term peak loads up to + 600 ° C;

Transportation Conditions: -30˚S to + 30ºC .

The PROTERM ® 600 material must be stored in enclosed fire and explosionproof rooms.

The products are packaged in metal, hermetically sealed buckets, with a volume of 3, 10 and 20 liters.

The shelf life of the prepacked material, if all conditions are met, is 12 months.

Translate »