Energy-saving coating PROTERM ANTIPIREN

Energy-saving coating PROTERM ANTIPIREN

Modification, provides refractory properties of structures.

This modification was developed to solve problems with thermal insulation and simultaneous protection from flame and destruction of load-bearing structures of buildings and structures, as well as energy objects with an increased risk of fire. Coverage fully complies with sanitary and fire regulations. PROTERM ® ANTIPIREN can be used on any surfaces and building structures. The material is resistant to the effects of aqueous salt solutions and alkalis, sediments and changes in temperature conditions.

The use of energy-saving coatings allows simultaneous achievement of several goals:

The possibility of using coatings throughout the perimeter of the building both inside and outside;

prevention of thermal burns of personnel;

reduction of labor, time and financial investments for repair and construction works;

preservation of the initial load on building structures;

optimization of the temperature regime inside buildings and structures;

the possibility to apply a coating on facades with a complex design and preserve the historical appearance of buildings;

facilities and process equipment at oil and gas enterprises.

Energy-saving coatings PROTERM ® can be applied with paint tools and airless sprayers.

Methods of application:

Pneumatic – pressure 1,5 – 3,5 atm;

Airless – pressure 80-120 bar, nozzle diameter (inch) – 0.013 0.015, 0.017;

Spray angle depending on the shape of the surface to be painted 20, 30, 40;

Manual – roller (without pile, preferably velor) and brushes made of natural fibers;

When applied to the surface, a smooth wet film should be formed without omissions, streaks, shakiness and other defects.

Main parameters of use:

Applied at ambient temperature: from + 7 ° C to + 45 ° C, relative air humidity not more than 80% ;

It is forbidden to paint on a damp surface and at a wind speed of more than 10 m / s;

It is applied on surfaces with temperature: from + 7 ° C to + 45 ° C, the temperature of the surface to be
painted should be 5 ° C above the dew point;

Recommended thickness of one wet layer: 0.5 mm – 1.0 mm ;

Interval overlap at t in = + 20 ° C: 24 hours;

Theoretical consumption of the material: 1,2-1,5 l / m 2 ; 0,5-0,7 kg / m 2 – with a layer thickness of 1 mm;

The main color of the coating is white, it is allowed to tint according to RAL;

The solvent is water;

Transportation conditions: + 7 ° C to + 40 ° C.

The PROTERM ® ANTIPIREN material should be stored in closed, ventilated areas .

The products are packaged in plastic, hermetically sealed buckets, with a volume of 5, 10 and 20 liters.

The shelf life of the prepacked material, if all conditions are met, is 12 months.

Translate »